Danfoss OMV800 Hydraulic Motor,OMV800 Danfoss Hydraulic Orbital Motor

Danfoss OMV800 Hydraulic Motor,OMV800 Danfoss Hydraulic Orbital Motor

Rolling bearing design, can withstand higher lateral forces.


The imported shaft seal design can withstand high back pressure and can be used in series and parallel.


The forward and reverse conversion is convenient and the speed is stable.


A variety of oil ports, output shafts, flanges and other connection forms.


1. Intermittent refers to the inlet pressure, and continuous working pressure refers to the working pressure difference.






2. The motor should not work under pressure and speed at the same time.






3. The running time of the motor should not exceed 10% under intermittent working conditions.






4. The working temperature is 80°.






5. The allowable back pressure of the motor is 10MPa, but it is recommended that the back pressure should not exceed 5MPa, and the external drain pipe should be connected when it exceeds.






6. Before the motor works at full load, it is recommended to run in for 1 hour below 40% of the working pressure.






7. It is recommended to use 68# anti-wear hydraulic oil, viscosity 37-73cSt, cleanliness ISO18/13.


OMV Cycloid Motor Sweeper OMV/BMV/8K Series Cycloid Hydraulic Motor


6K motor drilling rig rotary cycloid motor Eaton 6K-245 cycloid hydraulic motor


Eaton 6K-490 Hydraulic Cycloid Motor 6K Hydraulic Motor


Drilling Rig Hydraulic Motor 6K-985 Eaton Motor Hydraulic Motor Wheel Cycloid Motor 6K-390 Motor

Hydraulic pump test stand,Hydraulic Motor Test Stand,Gear Pump Test Bench
https://jinanyy.en.alibaba.com
http://www.yuanyihyd.com/en/
whatsapp:+8615154196819
email:admin@chinasdhydraulic.com
https://twitter.com/rexrothpump
https://www.facebook.com/Yuanyihyd